Control4 CCZ-T1-W Guía de instalación descargar pdf (Pagina 32)

Sample Wiring Conﬁgurations

WARNING! Do not install LINE VOLTAGE wires to a LOW VOLTAGE wire.

IMPORTANT! When utilizing power stealing, Control4 recommends installing the

included 270 Ohm bypass resistor on the HVAC system to minimize any potential

side eects. See the previous section “Installing a Bypass Resistor to Enable Power

Stealing on a Wireless Thermostat.”

IMPORTANT! Do not install any Remote Temperature Sensors to the TS terminals

other than supported external temperature sensors (Flush Mount Remote Tempera-

ture Sensor, Aprilaire™ Model 8051 or Duct/Outdoor Remote Temperature Sensor,

Aprilaire Model 8052, etc.). For installation instructions, see your Aprilaire docu-

mentation.

IMPORTANT! Install the U-shaped Terminal jumper wire between RC and RH for a

single stage system.

The next several pages provide sample Thermostat connections and conﬁgurations for

your reference.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Sin comentarios

Control4 CCZ-T1-W Guía de instalación Pagina 32